Replacement of a rotor of the sensor of a forward wheel. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. General information
9.2. Brake mechanisms of forward wheels
9.3. Brake mechanisms of back wheels of drum-type type
9.4. Brake mechanisms of back wheels of disk type
9.5. Drive of brakes
9.6. Anti-blocking system of brakes
9.6.1. Action principle
9.6.2. Removal and ABS hydrounit installation
9.6.3. Check and replacement of sensors of speed
9.6.4. Replacement of a rotor of the sensor of a forward wheel
9.6.5. Replacement of a rotor of the sensor of a back wheel
9.6.6. ABS diagnostics
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

9-6-4-zamena-rotora-datchika-perednego-kolesa.html

9.6.4. Replacement of a rotor of the sensor of a forward wheel

The rotor of the sensor is established with a tightness therefore its removal is possible only by means of a stripper.

Fig. 7.20. Removal of a rotor of the sensor of speed of rotation of a forward wheel


Lift a wheel from the necessary party. Remove a shaft of a drive of a wheel (see above). Clamp a drive shaft in a vice with soft sponges and by means of a stripper remove a rotor from a landing surface of a shaft (fig. 7.20).
Before installation of a rotor clear a landing surface of a shaft of a drive of a wheel. Rotor installation on a shaft make by means of a hammer, rebuffing a rotor in easy blows through wooden whetstone.

Fig. 7.18. Bolt of fastening of the sensor of speed of rotation of a forward wheel: 1 — a place for check of a gap of the sensor


Check a gap between a rotor and the sensor (see fig. 7.18).
Execute the remained operations as it should be, the return to removal.

«previous page
9.6.3. Check and replacement of sensors of speed
following page»
9.6.5. Replacement of a rotor of the sensor of a back wheel