9.6.3. Check and replacement of sensors of speed

Fig. 7.18. Bolt of fastening of the sensor of speed of rotation of a forward wheel: 1 — a place for check of a gap of the sensor

Turn out a bolt of fastening of the sensor of a forward wheel (fig. 7.18) and take out the sensor from a landing nest. To Otsoyediniteta the electric socket also measure resistance of the sensor which should make 0,8 — 1,2 kiloohms. In case of discrepancy of the measured resistance to the specified value replace the sensor.

Fig. 7.19. Fastening of a wire of the sensor of speed of rotation of a back wheel. The arrow showed the sensor of speed of rotation of a wheel

Replacement of the sensor of speed of rotation of a back wheel is easy for executing, being guided by fig. 7.19. Disconnect fastenings of its wire. Resistance of the sensor same, as at the sensor of a forward wheel.

At installation of sensors check gap size between the sensor and a rotor.