Air removal from a hydraulic actuator of brakes. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. General information
9.2. Brake mechanisms of forward wheels
9.3. Brake mechanisms of back wheels of drum-type type
9.4. Brake mechanisms of back wheels of disk type
9.5. Drive of brakes
9.5.1. Removal and installation of the main brake cylinder
9.5.2. Removal and installation of the vacuum amplifier
9.5.3. Air removal from a hydraulic actuator of brakes
9.5.4. Adjustment of lay brake system
9.6. Anti-blocking system of brakes
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4 íîâîñòíîé ïîðòàë èçðàèëÿ íîâîñòíîé ïîðòàë èçìàèëà íîâîñòíîé ñàéò êàçàõñòàíà

9-5-3-udalenie-vozdukha-iz-gidroprivoda-tormozov.html

9.5.3. Air removal from a hydraulic actuator of brakes

On the cars completed with ABS system, at performance of this operation it is necessary to disconnect electronic control by system previously.
Removal of air is necessary to make every time after the operations connected with a detachment of pipelines, replacement of brake cylinders or at air hit in system because of its leakage. The brake system of the car consists of two independent contours therefore air removal from it is carried out in the following order: 1st contour: back right wheel, forward left wheel; then 2nd contour: back left wheel, forward right wheel.
For performance of this operation it is recommended to use the special installation deleting air from system under pressure.
«previous page
9.5.2. Removal and installation of the vacuum amplifier		 following page»
9.5.4. Adjustment of lay brake system