Removal and installation of the vacuum amplifier. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. General information
9.2. Brake mechanisms of forward wheels
9.3. Brake mechanisms of back wheels of drum-type type
9.4. Brake mechanisms of back wheels of disk type
9.5. Drive of brakes
9.5.1. Removal and installation of the main brake cylinder
9.5.2. Removal and installation of the vacuum amplifier
9.5.3. Air removal from a hydraulic actuator of brakes
9.5.4. Adjustment of lay brake system
9.6. Anti-blocking system of brakes
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

9-5-2-snyatie-i-ustanovka-vakuumnogo-usilitelya.html

9.5.2. Removal and installation of the vacuum amplifier

Remove the main brake cylinder. On cars with the diesel engine remove, without disconnecting hoses, an arm with the fuel filter. Disconnect a vacuum hose from the vacuum amplifier. Remove the bottom board on a body floor. Remove sound insulation about a pedal. Remove spring шплинт and take an axis connecting a fork of the vacuum amplifier to a pedal of a brake. Unscrew four nuts of fastening of the vacuum amplifier to a pedal arm. Remove laying, take aside and remove the vacuum amplifier.

Fig. 7.14. Check of the vacuum amplifier:
And — check of length of a vystupaniye of a rod of the vacuum amplifier at the depression appendix:
and = 10,2 — 10,5 mm; B — check of length of a pusher of the vacuum amplifier: = 125 mm; 1 — an adjusting nut; 2 — a lock-nut


Before installation check the size "a" of a vystupaniye of a rod which should make 10,2 — 10,5 mm (fig. 7.14) at the annex to a hose of the vacuum amplifier of depression of 500 mm of a mercury column (33,332 kPas).
"Would" measure distance from the privalochny plane of the vacuum amplifier to an axis of an adjusting fork which 125 mm should be. Adjust it by means of nuts
1 and 2. Installation make in sequence, return to removal. Thus tighten carving connections by the ordered moment. Remove air from a hydraulic actuator of brakes. Check distance between a body floor and a pedal. In case of need make adjustment.

«previous page
9.5.1. Removal and installation of the main brake cylinder
following page»
9.5.3. Air removal from a hydraulic actuator of brakes