Replacement of brake shoes. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. General information
9.2. Brake mechanisms of forward wheels
9.2.1. Replacement of brake shoes
9.2.2. Removal and installation of the brake mechanism
9.2.3. Replacement of a brake disk
9.3. Brake mechanisms of back wheels of drum-type type
9.4. Brake mechanisms of back wheels of disk type
9.5. Drive of brakes
9.6. Anti-blocking system of brakes
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4

9-2-1-zamena-tormoznykh-kolodok.html

9.2.1. Replacement of brake shoes


Fig. 7.5. Removal of the bottom directing finger of fastening of a support


Replacement of brake shoes make at the same time on both forward wheels. Blocks establish only recommended brand. Lift a forward part of the car and put it on supports. Remove forward wheels, having noted their situation concerning naves.

Fig. 7.6. Removal of brake shoes


Pump out a syringe a part of brake liquid from a tank. By means of a screw-driver slightly drown the piston in the support cylinder. Turn out a bolt of fastening of the bottom finger of a support (fig. 7.5), holding a finger with other key. Turn a support up and take out brake shoes (fig. 7.6).
Before installation of new brake shoes check:
— technical condition and provision of a dustproof cuff of the piston of the cylinder;
— a technical condition of directing fingers and their protective covers (clear and grease directing fingers if necessary);
— absence of leakages of brake liquid;
— degree of wear of a brake disk and condition of its surface.
Move the piston as it is possible more deeply in the cylinder. Establish new brake shoes and put a support into place. Wrap the removed bolt of fastening of the bottom finger of a support and tighten it the set moment. Execute the remained operations as it should be, the return to removal.
Several times press a brake pedal for installation of pistons in brake cylinders into position. Finish to norm level of brake liquid in a tank.


«previous page
9.2. Brake mechanisms of forward wheels
following page»
9.2.2. Removal and installation of the brake mechanism