Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of central air of air
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air line
8.5.9. Removal and installation of the compressor of central air of air
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and condenser installation
8.5.14. Condenser check
8.5.15. Removal and installation of lines of a coolant (LF)
8.6. Tables
 








8-5-6-kondensator.html

8.5.6. Condenser

The condenser with additional cooling is used. It is the multiline condenser which is equipped with an element of additional cooling and it is incorporated with a receiver/moisture separator.

Condenser
Fig. 8.66. Condenser: 1–condenser; 2–cooling element; 3–element of additional cooling; 4–receiver/moisture separator


The condenser with additional cooling divides gas and liquid phases of the coolant which has been originally cooled in the condenser, in a receiver/moisture separator where the coolant again comes back to an element of additional cooling and is again cooled for acceleration of liquefaction and improvement of cooling ability.


«previous page
8.5.5. Broad valve
following page»
8.5.7. Check of a radiator of a heater