Adjustment of an emphasis of a lath. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
8.1. General information
8.2. Steering repair
8.2.1. Removal and installation of a shaft of a steering
8.2.2. Removal and installation of the steering mechanism
8.2.3. Check of a free wheeling of a steering wheel
8.2.4. Check of axial moving of the mechanism
8.2.5. Check of effort of turn of a steering wheel
8.2.6. Check of effort of moving of a gear lath
8.2.7. Adjustment of an emphasis of a lath
8.2.8. Removal and installation of the pump of the hydraulic booster
8.2.9. Dismantling and assembly of the pump of the hydraulic booster
8.2.10. Air removal from system of the hydraulic booster
8.2.11. Adjustment of a tension of a belt of a drive of the hydraulic booster
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

8-2-7-regulirovka-upora-rejjki.html

8.2.7. Adjustment of an emphasis of a lath


Fig. 6.7. Adjustment of an emphasis of a lath: 1 — the screw of adjustment of an emphasis of a lath; 2 — a lock-nut; 3 — a lath emphasis; 4 — a lath


Remove the steering mechanism and establish its case in a vice with soft sponges. Turn out the adjusting screw of an emphasis of a lath (fig. 6.7), put on a carving part of the screw a layer of hermetic and again wrap the adjusting screw. Slightly wrap a lock-nut. Tighten the adjusting screw the moment of 5 — 6 N · m; turn out the adjusting screw, then tighten it the moment of 0,2 N · m.

Fig. 6.8. Measurement of the moment of rotation of a gear wheel of a lath: 1 — the Nissan KV48100700 adaptation; 2 — the Nissan ST3127S000 adaptation


Move several times a lath for all length of a course. Measure by means of a dinamometrichesky key (Nissan ST3127S000 adaptation) and an adapter (Nissan KV48100700 adaptation) (fig. 6.8) the moment of a provorachivaniye of a gear wheel of a lath. Establish a lath gear wheel in the point corresponding to the maximum measured moment. Release, then tighten the adjusting screw the moment of 4,9 N · m. Release the adjusting screw on 70 — 110 °. Tighten a lock-nut the set moment.

«previous page
8.2.6. Check of effort of moving of a gear lath
following page»
8.2.8. Removal and installation of the pump of the hydraulic booster