Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.2.1. Removal and cowl installation
8.2.2. Adjustment of provision of a cowl
8.2.3. Removal and installation of the panel of a forward wing
8.2.4. Removal and installation of a front bumper
8.2.5. Removal and installation of a rear bumper
8.2.6. Doors
8.2.7. Removal and installation of a forward door
8.2.8. Removal and installation of a back door
8.2.9. Door adjustment
8.2.10. Adjustment of a door of a back
8.2.11. Removal and installation of glass of a forward door
8.2.12. Removal and installation of glass of a back door
8.2.13. Removal and installation of the block of a forward door
8.2.14. Removal and installation of the block of a back door
8.2.15. Window regulators
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.6. Tables
 








8-2-5-snyatie-i-ustanovka-zadnego-bampera.html

8.2.5. Removal and installation of a rear bumper

Disconnect a negative wire from the storage battery.
Remove an overlay of a luggage carrier.
Remove fastenings and unbend a lateral overlay of a luggage carrier a little. (right)
Remove fastenings and unbend a lateral overlay of a luggage carrier a little. (left) (4SD)
Uncover a technological opening. (left) (5HB)
Remove the back combined lamp.
Disconnect the socket of a lamp of illumination of registration plate.

Removal of a rear bumper
Fig. 8.15. Removal of a rear bumper: 1–screw A; 2–screw B; 3–screw C; 4–A connector; 5–A bolt; 6–B connector; 7–rear bumper; 8–reflector; 9–B bolt; 10-amplifier of a rear bumper


Remove in an order shown in drawing 8.15.
Remove a rear bumper.
Take away edges of a rear bumper (a wheel niche) outside.
Attach a rear bumper to a body.
Press on connecting parts of a rear bumper in the direction to a body to insert them into bumper locks.
Establish as it should be, the return to removal.

«previous page
8.2.4. Removal and installation of a front bumper
following page»
8.2.6. Doors