Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.2.1. Removal and cowl installation
8.2.2. Adjustment of provision of a cowl
8.2.3. Removal and installation of the panel of a forward wing
8.2.4. Removal and installation of a front bumper
8.2.5. Removal and installation of a rear bumper
8.2.6. Doors
8.2.7. Removal and installation of a forward door
8.2.8. Removal and installation of a back door
8.2.9. Door adjustment
8.2.10. Adjustment of a door of a back
8.2.11. Removal and installation of glass of a forward door
8.2.12. Removal and installation of glass of a back door
8.2.13. Removal and installation of the block of a forward door
8.2.14. Removal and installation of the block of a back door
8.2.15. Window regulators
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.6. Tables
 








8-2-4-snyatie-i-ustanovka-perednego-bampera.html

8.2.4. Removal and installation of a front bumper

Disconnect a negative wire of the storage battery.

Detachment of the lock of a bumper
Fig. 8.13. Detachment of the lock of a bumper


Delay the ends of a front bumper (a wheel niche) outside to uncouple the bumper lock (fig. 8.13).

Removal of a front bumper
Fig. 8.14. Removal of a front bumper: 1–screw A; 2–A connector; 3–screw B; 4–bolt; 5–B connector; 6–front bumper


Remove in an order shown in drawing 8.14.
Remove a front bumper.

ATTENTION
If the front bumper is released only on the one hand at bumper falling, it can be damaged. At release of the lock of a front bumper, fix a bumper so that it did not fall.

Dissolve the ends of a front bumper (a wheel niche).
Attach a front bumper to a body.
Press on connecting parts of a front bumper in the direction to a body to insert them into bumper locks.
Establish as it should be, the return to removal.

«previous page
8.2.3. Removal and installation of the panel of a forward wing
following page»
8.2.5. Removal and installation of a rear bumper