Removal and installation of the steering mechanism. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
8.1. General information
8.2. Steering repair
8.2.1. Removal and installation of a shaft of a steering
8.2.2. Removal and installation of the steering mechanism
8.2.3. Check of a free wheeling of a steering wheel
8.2.4. Check of axial moving of the mechanism
8.2.5. Check of effort of turn of a steering wheel
8.2.6. Check of effort of moving of a gear lath
8.2.7. Adjustment of an emphasis of a lath
8.2.8. Removal and installation of the pump of the hydraulic booster
8.2.9. Dismantling and assembly of the pump of the hydraulic booster
8.2.10. Air removal from system of the hydraulic booster
8.2.11. Adjustment of a tension of a belt of a drive of the hydraulic booster
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4

8-2-2-snyatie-i-ustanovka-rulevogo-mekhanizma.html

8.2.2. Removal and installation of the steering mechanism

In case of malfunction the steering mechanism is replaced assembled. Disconnect a wire from the negative plug of the storage battery. Establish forward wheels in the provision of rectilinear movement. By means of a syringe pump out working liquid from a tank of the hydraulic booster.

Fig. 6.3. Bolts of fastening of brackets of a case of the steering mechanism to a body cross-piece


Remove a protective casing of a steering column for access and to the kardanny hinge. Mark the provision of a steering shaft. Turn out a bolt of fastening of the kardanny hinge. Remove an antisplash guard of the left wheel. Disconnect from rotary fists steering drafts for what расшплинтуйте and unscrew nuts and выпрессуйте a stripper fingers of hinges from openings in rotary fists. Remove a reception pipe of the exhaust silencer. Separate connecting draft from a transmission. Press pipelines of the hydraulic booster and disconnect the union from a case of the steering mechanism, having muffled openings jams. Turn out bolts of fastening of the steering mechanism to a body cross-piece (fig. 6.3) and take out the steering mechanism through an arch of the left wheel.

Fig. 6.4. Preliminary adjustment of length of steering draft: X = 187 mm


Fig. 6.5. Lath moving: And = 65 mm


Fig. 6.6. Order of an inhaling of bolts of support of fastening of a case of the steering mechanism


Installation carry out to sequences, return to removal. Attaching steering bent for to rotary fists, establish distance X, equal 187 mm (fig. 6.4). Check size of moving of a lath of the steering mechanism which should make 65 mm to the right and to the left (fig. 6.5), otherwise replace the steering mechanism. Establish a shaft of a steering and a gear wheel of the steering mechanism on the labels put at removal. Tighten bolts of support of fastening of the steering mechanism in an order shown on fig. 6.6. Replace sealing rings of unions of pipelines. Remove air from system of the hydraulic booster of the steering mechanism. Check and if necessary adjust corners of installation of wheels.


«previous page
8.2.1. Removal and installation of a shaft of a steering
following page»
8.2.3. Check of a free wheeling of a steering wheel