Removal and installation of a shaft of a steering. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
8.1. General information
8.2. Steering repair
8.2.1. Removal and installation of a shaft of a steering
8.2.2. Removal and installation of the steering mechanism
8.2.3. Check of a free wheeling of a steering wheel
8.2.4. Check of axial moving of the mechanism
8.2.5. Check of effort of turn of a steering wheel
8.2.6. Check of effort of moving of a gear lath
8.2.7. Adjustment of an emphasis of a lath
8.2.8. Removal and installation of the pump of the hydraulic booster
8.2.9. Dismantling and assembly of the pump of the hydraulic booster
8.2.10. Air removal from system of the hydraulic booster
8.2.11. Adjustment of a tension of a belt of a drive of the hydraulic booster
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

8-2-1-snyatie-i-ustanovka-vala-rulevogo-upravleniya.html

8.2.1. Removal and installation of a shaft of a steering

Remove a wire from the negative plug of the storage battery. Wait for 10 minutes, then remove the safety cushion module (see. "Body"). Establish forward wheels in the provision of rectilinear movement. Unscrew a nut of fastening of a steering wheel and remove it by means of a stripper, having marked its situation on the helmsman to a shaft. Release a protective casing on a body floor. Having turned out screws, remove both half of a facing casing of a shaft of a steering. Remove the block of podrulevy switches. Separate the kontakty socket of the lock of ignition. Remove a protective casing of a shaft of a steering. Turn out a bolt of fastening of the kardanny hinge connecting a steering shaft to the reechny mechanism. Unscrew nuts of fastening of an arm of a pipe of a shaft of a steering and remove a pipe with steering shaft assembled.
Installation carry out as it should be, the return to removal, taking into account the following.
Before connection of the plug of the storage battery be convinced that in salon there are no people — possibly safety cushion operation.

Fig. 6.2. Check of length of a shaft of a steering: And = 533 — 535 mm


Be convinced that the length of a shaft And a steering is in limits of 533 — 535 mm (fig. 6.2), otherwise replace a shaft.
Be convinced that during rectilinear movement of the car of a spoke of a steering wheel are located horizontally, and number of turns of a steering wheel from average situation in both parties equally.

«previous page
8.2. Steering repair
following page»
8.2.2. Removal and installation of the steering mechanism