Replacement of a nave of a back wheel. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.2. Back suspension bracket
7.2.1. Removal and installation of a rack of a back suspension bracket
7.2.2. Dismantling and assembly of a rack of a back suspension bracket
7.2.3. Removal and installation of a beam of a back suspension bracket
7.2.4. Replacement of a nave of a back wheel
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

7-2-4-zamena-stupicy-zadnego-kolesa.html

7.2.4. Replacement of a nave of a back wheel

Nave — not folding knot therefore for replacement of the bearing it is necessary to replace a nave assembled.

Fig. 5.19. Nave fastening: 1 — a nut of fastening of a nave; 2 — шплинт


Lift a back part of the car, put it on supports and remove a wheel from the necessary party. Depending on a complete set remove a brake drum or directing brake shoes and a brake disk (see. «Brake system»). Remove a protective cap of a nave and take out шплинт 2 (fig. 5.19) of a nut of 1 nave. Unscrew a nut. Remove a nave of a back wheel.
Installation of a nave carry out as it should be, the return to removal, taking into account the following.
Check a nave surface, a condition of a carving part.
Replace шплинт.
Before installation of a cap fill it with greasing.
The axial gap of a nave checked by the indicator, should make no more
0,05 mm.

«previous page
7.2.3. Removal and installation of a beam of a back suspension bracket
following page»
8. Steering