Dismantling and assembly of a rack of a back suspension bracket. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.2. Back suspension bracket
7.2.1. Removal and installation of a rack of a back suspension bracket
7.2.2. Dismantling and assembly of a rack of a back suspension bracket
7.2.3. Removal and installation of a beam of a back suspension bracket
7.2.4. Replacement of a nave of a back wheel
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4

7-2-2-razborka-i-sborka-stojjki-zadnejj-podveski.html

7.2.2. Dismantling and assembly of a rack of a back suspension bracket


Fig. 5.15. Provision of the bottom cup of a spring and top support: And — the arrow indicating to a forward part of the car; B — the left rack;
In — the right rack; 1 — the provision of the bottom end of a spring; 2 — an axis, perpendicular axes of an opening of the bottom plug of the shock-absorber


Fig. 5.16. Provision of a spring of a suspension bracket:
1 — the bottom basic cup of a spring; 2 — the top demountable support of a spring; 3 — the top round of a spring


Dismantling of a rack of a back suspension bracket is similar to dismantling of a forward rack. Replacement of shock-absorbers and springs is recommended to be carried out also in pairs, i.e. from the left and right side. At installation of springs and basic cups follow instructions fig. 5.15 and 5.16. Finally tighten carving connections after lowering of wheels on the earth.


«previous page
7.2.1. Removal and installation of a rack of a back suspension bracket
following page»
7.2.3. Removal and installation of a beam of a back suspension bracket