Removal and installation of a cross-piece of a forward suspension bracket. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Removal and installation of a rack of a forward suspension bracket
7.1.2. Dismantling and assembly of a rack of a forward suspension bracket
7.1.3. Removal and installation of the stabilizer of cross-section stability
7.1.4. Removal and installation of a cross-piece of a forward suspension bracket
7.1.5. Check and adjustment of corners of installation of forward wheels
7.1.6. Replacement of the bearing of a nave of a forward wheel
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4 best canadian pharmacies

7-1-4-snyatie-i-ustanovka-poperechiny-perednejj-podveski.html

7.1.4. Removal and installation of a cross-piece of a forward suspension bracket


Fig. 5.2. Type of a forward suspension bracket: 1 — bolts of fastening of a back support of the lever of a forward suspension bracket; 2 — a bolt of fastening of a forward support of the lever of a suspension bracket; 3 — a nut of fastenings of a rack of the stabilizer of cross-section stability; 4 — bolts of fastening of the stabilizer of cross-section stability;
5 — bolts of fastening of a cross-piece of a forward suspension bracket to a body


Lift and establish on supports a forward part of the car. Remove wheels. Block from rotation a wheel nave. Take out шплинт lock-nuts and unscrew a nut of fastening of a nave. Unscrew a nut of fastening of a finger of the spherical hinge of steering bent for to a rotary fist. By means of a stripper disconnect steering draft from a rotary fist. Unscrew a nut of fastening of the spherical hinge of the bottom lever of a suspension bracket and by means of a stripper disconnect the lever from a rotary fist. Take aside a rotary fist and a rack and take out from a nave a shaft of the external hinge of a shaft of a drive of a forward wheel. The same operations execute on the other side of the car. Remove the stabilizer of cross-section stability. Turn out bolts of fastening of forward and back support (see fig. 5.2) the suspension bracket lever from both parties of the car. Remove both levers of a suspension bracket.
On cars with the petrol engine remove thermoisolating screen of a reception pipe of the exhaust silencer. Remove a reception pipe of the exhaust silencer. Remove connecting draft and drafts of a drive of gear shifting. Supporting the power unit, remove from the bottom cross-section support forward and back arms of a suspension bracket of the power unit. Remove the bottom cross-section support of the power unit. Unscrew bolts of fastening of a case of the steering mechanism to a cross-piece of a forward suspension bracket. By means of one or several jacks prop up a cross-piece of a suspension bracket and turn out two bolts and four nuts of fastening of a cross-piece of a forward suspension bracket to a car body. Slowly lower a suspension bracket cross-piece, watching to hooking on units or the details of fastening located close.
Installation is carried out to sequences, return to removal.
Finally tighten carving connections after lowering of wheels of the car. Check tightness of system of release and adjust corners of installation of forward wheels.

«previous page
7.1.3. Removal and installation of the stabilizer of cross-section stability
following page»
7.1.5. Check and adjustment of corners of installation of forward wheels