Dismantling and assembly of a rack of a forward suspension bracket. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Removal and installation of a rack of a forward suspension bracket
7.1.2. Dismantling and assembly of a rack of a forward suspension bracket
7.1.3. Removal and installation of the stabilizer of cross-section stability
7.1.4. Removal and installation of a cross-piece of a forward suspension bracket
7.1.5. Check and adjustment of corners of installation of forward wheels
7.1.6. Replacement of the bearing of a nave of a forward wheel
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4

7-1-2-razborka-i-sborka-stojjki-perednejj-podveski.html

7.1.2. Dismantling and assembly of a rack of a forward suspension bracket


Fig. 5.7. Otvorachivaniye of a nut of a rod of the shock-absorber


Establish the removed rack in a vice. By means of the adaptation for compression of springs compress a spring before release of the top and bottom support of a rack. Unscrew a nut of a rod of the shock-absorber (fig. 5.7).
Remove the details which were over a spring. If do not assume to collect a rack soon, carefully unclench a spring. Shock-absorbers and springs always replace in pairs, i.e. on the right and left wheels.
For assembly compress a spring if it was released after dismantling. Establish into place removed details in sequence, return to removal. "Acquire", but do not tighten a nut on a shock-absorber rod. Finally tighten a nut after car installation on wheels. Slowly release a spring, watching that it occupied the correct situation concerning support. Establish on the car a rack of a forward suspension bracket assembled.

«previous page
7.1.1. Removal and installation of a rack of a forward suspension bracket
following page»
7.1.3. Removal and installation of the stabilizer of cross-section stability