Dismantling and differential assembly. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
6.1. Coupling
6.2. Mechanical transmission
6.2.1. General information
6.2.2. Removal and transmission installation
6.2.3. Transmission dismantling
6.2.4. Dismantling of primary shaft
6.2.5. Assembly of primary shaft
6.2.6. Dismantling of a secondary shaft
6.2.7. Assembly secondary валаф
6.2.8. Dismantling and differential assembly
6.2.9. Transmission assembly
6.3. Automatic transmission
6.4. Drive of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4

6-2-8-razborka-i-sborka-differenciala.html

6.2.8. Dismantling and differential assembly


Fig. 4.37. Knocking-out of a pin of fastening of an axis of satellites


For dismantling of differential establish a differential box in a vice with soft sponges. Beat out a pin of fastening of an axis of satellites (fig. 4.37), take an axis and take out satellites and semi-axial gear wheels.
Remove a gear wheel of the main transfer, previously having marked an arrangement of details. Take out conic bearings.
Check a technical condition of details. Replace bearings if they have scratches, traces of an overheat or excessive wear. The axis of satellites should not have traces of jamming or wear, an excessive gap in the case, otherwise it is necessary to replace it. The working surface of teeths of satellites and semi-axial gear wheels should not be painted or excessively worn-out.

Fig. 4.38. Measurement of axial moving of semi-axial gear wheels of the main transfer


Before assembly establish into place semi-axial gear wheels and satellites with washers. Then establish an axis of satellites. Measure axial moving of semi-axial gear wheels (fig. 4.38) which no more than 0,3 mm should be. At bigger moving pick up washers of the corresponding thickness. Establish a new pin of fastening of an axis of satellites. Put a layer of kontrovochny paste on bolts of fastening and establish a gear wheel of the main transfer. Tighten fixing bolts the moment of 80 N · m.

«previous page
6.2.7. Assembly secondary валаф
following page»
6.2.9. Transmission assembly