Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of brake system
6.2.2. Check of level of brake liquid in a tank of a hydraulic actuator of working brake system
6.2.3. Air removal from brake system
6.2.4. Check of the return valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.5.1. Check of a pedal of a brake
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of forward brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of lay brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 








6-2-5-snyatie-i-ustanovka-vakuumnogo-shlanga-usilitel-tormozov.html

6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)

Detachment of the socket of a vacuum hose
Fig. 6.11. Detachment of the socket of a vacuum hose


Disconnect the socket of a vacuum hose from the amplifier of brakes, pressing uvulas of the socket of a vacuum hose (fig. 6.11).

Collar removal
Fig. 6.12. Collar removal


Remove a collar, using flat-nose pliers, and disconnect a vacuum hose from an inlet collector (Z6) (fig. 6.12).

Detachment of a vacuum hose from an inlet collector
Fig. 6.13. A detachment of a vacuum hose from an inlet collector


Insert a thin screw-driver with a flat shliyets in a point designated by an arrow in drawing 6.13, displace a ring down and disconnect a vacuum hose from an inlet collector (LF).
Remove a vacuum hose.
Establish as it should be, the return to removal.
Be convinced of that the vacuum hose is inserted so that connection of a vacuum hose concerns a ring of an inlet collector (LF).
Insert the socket of a vacuum hose in the amplifier of brakes.
Be convinced of that the vacuum hose is established reliably, having pulled for it, and again insert it in the amplifier of brakes.

Installation of the coil of the amplifier of brakes
Fig. 6.14. Installation of the coil of the amplifier of brakes


Be convinced of that the coil of the amplifier of brakes is in the socket of a vacuum hose (fig. 6.14).

«previous page
6.2.4. Check of the return valve of a vacuum hose (amplifier of brakes)
following page»
6.2.5.1. Check of a pedal of a brake