Pumping of a hydraulic actuator of coupling. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
6.1. Coupling
6.1.1. General information
6.1.2. Removal and installation of the mechanism of coupling
6.1.3. Pumping of a hydraulic actuator of coupling
6.1.4. Adjustment of a full speed of a pedal of coupling
6.1.5. Adjustment of a free wheeling of the lever of switching off of coupling (on cars with a mechanical drive of coupling)
6.2. Mechanical transmission
6.3. Automatic transmission
6.4. Drive of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

6-1-3-prokachka-gidroprivoda-scepleniya.html

6.1.3. Pumping of a hydraulic actuator of coupling


Fig. 4.5. Main cylinder of a hydraulic drive of coupling: 1 — the pumping union;
2 — screws of fastening of a damper


Fill in in a tank of a hydraulic actuator of coupling working liquid to the maximum mark and watch, that its level did not go down during operation performance. Remove a protective cap from the union for pumping on the main cylinder (fig. 4.5) and put on the union a hose. Other end of a hose lower in the brake liquid poured in a transparent glass vessel. Slightly turn out the union for pumping, press against the stop a pedal of coupling and release it. Repeat this operation several times, the exit of vials from a hose will not stop yet. Wrap the union and put on it a cap. The same operation to execute on the working cylinder. After the completion of pumping of a hydraulic actuator of coupling be convinced of accurate work of a hydraulic actuator and the correct gear shifting in a transmission.
During pumping watch liquid level in a hydraulic actuator tank, without allowing an exposure of its bottom. The hose end for pumping should be constantly shipped in liquid.

«previous page
6.1.2. Removal and installation of the mechanism of coupling
following page»
6.1.4. Adjustment of a full speed of a pedal of coupling