Removal and installation of the mechanism of coupling. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
6.1. Coupling
6.1.1. General information
6.1.2. Removal and installation of the mechanism of coupling
6.1.3. Pumping of a hydraulic actuator of coupling
6.1.4. Adjustment of a full speed of a pedal of coupling
6.1.5. Adjustment of a free wheeling of the lever of switching off of coupling (on cars with a mechanical drive of coupling)
6.2. Mechanical transmission
6.3. Automatic transmission
6.4. Drive of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4 canada online shopping

6-1-2-snyatie-i-ustanovka-mekhanizma-scepleniya.html

6.1.2. Removal and installation of the mechanism of coupling


Fig. 4.3. Working cylinder (1) drive of coupling and union of pumping (2)


On cars with the petrol engine disconnect a drive cable from the lever of switching off of coupling. On cars with the diesel engine disconnect from a transmission the working cylinder of a drive of coupling (fig. 4.3), without disconnecting from it the pipeline; fix the cylinder so that it was not damaged. Remove a transmission as it is described below.

Fig. 4.4. Order of an inhaling of bolts of fastening of a casing of coupling assembled


As it should be, the return specified fig. 4.4, unscrew bolts of fastening of a casing of coupling. Previously note the provision of a casing on a flywheel. Remove a coupling casing together with press and conducted by disks. Clear the removed details and estimate their condition, being guided by the requirements provided in tab. 4.1. In case of the increased wear replace details. Degrease a flywheel surface solvent.
Establish into place conducted disk
by means of a centering opravka of Nissan KV 301016000 or another, the suitable size. Establish a coupling casing in collecting and fix it bolts as it is specified fig. 4.4, the set moment. Remove an opravka. Apply a thin film greasings on a shlitsa of primary shaft of a transmission and the bearing of switching off of coupling. Establish a transmission. On cars with the petrol engine connect a cable of a drive of management of coupling to the lever of a fork of switching off of coupling on a transmission. On cars with the diesel engine establish into place the working cylinder of a drive of coupling. Pump over a coupling drive.

«previous page
6.1.1. General information
following page»
6.1.3. Pumping of a hydraulic actuator of coupling