TNVD adjustment. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
5.1. General information
5.2. Block of cylinders and krivoshipnoshatunny mechanism
5.3. Gazoraspredeleniye mechanism
5.4. Cooling system
5.5. Greasing system
5.6. Power supply system
5.6.1. Design features
5.6.2. Removal and TNVD installation
5.6.3. TNVD adjustment
5.6.4. Check of adjustment of TNVD
5.6.5. Adjustment of idling of the CD20 engine
5.6.6. Adjustment of the maximum frequency of rotation without CD20 engine loading
5.6.7. Adjustment of the shock-absorber of a drive of management by supply of fuel
5.6.8. Replacement of a belt of a drive of TNVD
5.6.9. Air and sediment removal from the fuel filter and system of supply of fuel
5.7. Control system of the CD20 engine
5.8. Control system of the CD20E engine
5.9. System of production of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

5-6-3-regulirovka-tnvd.html

5.6.3. TNVD adjustment


Fig. 3.35. TNVD installation on labels and device shutdown for start-up of the cold engine by means of a plate in thickness of 15 mm (only on the CD20 engine)


Disconnect a wire of the "minus" plug of the storage battery. Separate all electrosockets, disconnect vacuum drives and the cables suitable to TNVD. Remove топливопроводы a high pressure, then disconnect bringing and drain топливопроводы from TNVD. On engines of the CD20 model disconnect the device for start-up of the cold engine by plate installation in thickness of 15 mm between the lever and the starting arrangement (fig. 3.35). Turn a cranked shaft and establish cut (without color marking) a pulley of a cranked shaft against a label on the block of cylinders (the piston in the 1st cylinder is in the provision VMT of a step of compression).

Fig. 3.36. TNVD c installation by the help of the indicator with an adapter (the adaptation
KV 11229350)


Establish the display KV 11229350 device with a support, having removed the carving stopper located on the center of the TNVD distributor (fig. 3.36). Weaken bolts of fastening of TNVD. Adjust position of the indicator so that his shooter settled down between divisions of 1 and 2 mm. Turn a cranked shaft on 20 — 25 ° (for the CD20 engine) or on 100 ° (for the CD20E engine) counter-clockwise. In this provision of a cranked shaft establish an arrow of the indicator on «0». Slowly turning a cranked shaft clockwise, establish a label of yellow color on a pulley of a cranked shaft against a label corresponding to an initial corner of an advancing of injection of fuel. For increase in a corner of an advancing of injection of fuel slowly turn the pump case in the direction «from the engine», for reduction — «to the engine» while the indicator will not show the set course of a plunzher of TNVD. Tighten in this situation bolts of fastening of TNVD and check adjustment of a corner of an advancing of injection of fuel.

«previous page
5.6.2. Removal and TNVD installation
following page»
5.6.4. Check of adjustment of TNVD