Check of pressure of oil. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
5.1. General information
5.2. Block of cylinders and krivoshipnoshatunny mechanism
5.3. Gazoraspredeleniye mechanism
5.4. Cooling system
5.5. Greasing system
5.5.1. General information
5.5.2. Removal, dismantling, assembly and installation of the oil pump
5.5.3. Check of pressure of oil
5.6. Power supply system
5.7. Control system of the CD20 engine
5.8. Control system of the CD20E engine
5.9. System of production of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4

5-5-3-proverka-davleniya-masla.html

5.5.3. Check of pressure of oil


Fig. 3.28. Placement of the sensor of pressure of oil


Remove the sensor of pressure established near the oil filter (fig. 3.28).
Connect instead of the sensor a manometer with a scale graduated from 0 to 1000 Pa.
Start up the engine and wait, while oil will heat up to temperature about 90 ° S.Zamerte pressure of oil in a mode of idling and at frequency of rotation of a cranked shaft of 2000 mines — 1.
Pressure of oil should make in a mode of idling of 60 Pas, and at frequency of rotation of a cranked shaft of 2000 mines — 1 — 300 Pa.
If the measured pressure does not correspond to the specified values, check operation of the reduktsionny valve and the oil pump.

«previous page
5.5.2. Removal, dismantling, assembly and installation of the oil pump
following page»
5.6. Power supply system