Removal and installation of the water pump. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
5.1. General information
5.2. Block of cylinders and krivoshipnoshatunny mechanism
5.3. Gazoraspredeleniye mechanism
5.4. Cooling system
5.4.1. Design features
5.4.2. Removal and installation of a belt of a drive of the water pump
5.4.3. Removal and installation of the water pump
5.4.4. Replacement of cooling liquid and air removal from system of cooling of the engine
5.5. Greasing system
5.6. Power supply system
5.7. Control system of the CD20 engine
5.8. Control system of the CD20E engine
5.9. System of production of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

5-4-3-snyatie-i-ustanovka-vodyanogo-nasosa.html

5.4.3. Removal and installation of the water pump

Establish on a support a forward part of the car. Remove the right wheel and the right antisplash guard. Merge liquid from cooling system. Unscrew bolts of fastening of a pulley of the water pump. Remove a belt of a drive of the mechanism of a gazoraspredeleniye, a tension roller and a pulley of the water pump. Remove the water pump, having unscrewed bolts of its fastening. Carefully clear by means of chemical solvent a privalochny surface of the water pump.
The water pump is not subject to repair. The faulty pump is replaced assembled. Before installation be convinced that the shaft of the pump has no люфта and that bearings do not make extraneous noise. Put a layer of hermetic of the Loctite type on a basic surface of the pump. Establish the pump on the engine and tighten the set moment fastening bolts. Establish the removed details in sequence, return to removal. To Otreguliruta belt tension. Check a tension of a belt of the mechanism of a gazoraspredeleniye. Fill system of cooling and remove from it air. Start up the engine and be convinced of lack of a leak of cooling liquid.

«previous page
5.4.2. Removal and installation of a belt of a drive of the water pump
following page»
5.4.4. Replacement of cooling liquid and air removal from system of cooling of the engine