5-4-2-snyatie-i-ustanovka-remnya-privoda-vodyanogo-nasosa.html
5.4.2. Removal and installation of a belt of a drive of the water pump
|
Fig. 3.23. Placement of the screw of adjustment of a tension of a belt of a drive of the water pump
|
Establish on a support a forward part of the car, remove on the right side a wheel, an antisplash mudguard and the right guard of a case of the engine. Weaken the top bolt of fastening of the pump of the hydraulic booster of a steering. Then, turning on the adjusting screw, weaken a tension of a driving belt (fig. 3.23). Remove a belt of a drive of the water pump.
|
Fig. 3.24. Belts of a drive of auxiliaries: 1 — a pulley of a cranked shaft;
2 — a pulley of the pump of the hydraulic booster of a steering; 3 — a pulley of the water pump; 4 — a generator pulley; 5 — a pulley of the compressor of the conditioner;
6 — a tension roller
|
Before installation of a belt check a condition of each pulley. Establish a belt as it is specified fig. 3.24, paying attention to laying of it in streams of all pulleys.
Adjust the screw a tension of a driving belt so that the deflection by pressing the branch middle between pulleys of the water pump and the pump of the hydraulic booster of a steering effort of 98 N made for a new belt 3 —
4 mm, for the earned extra belt of 5 — 7 mm.
Tighten the top bolt of fastening of the pump of the hydraulic booster of a steering. Execute the remained operations as it should be, the return to removal.
|