Washing and filling of system of cooling. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and engine assembly
4.3. Block of cylinders
4.4. Shatunno-porshnevaya group
4.5. Cranked shaft and flywheel
4.6. Gazoraspredeleniye mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.9.1. Removal, installation and adjustment of a tension of a belt of a drive of the water pump
4.9.2. Removal and installation of the water pump
4.9.3. Washing and filling of system of cooling
4.10. Greasing system
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex control system of the engine (KSUD)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

4-9-3-promyvka-i-zapravka-sistemy-okhlazhdeniya.html

4.9.3. Washing and filling of system of cooling


Fig. 2.70. Arrangement of jams of drain openings of system of cooling: And — a stopper liquid plum from a shirt of the block of cylinders; B — a stopper on the bottom tank of a radiator


Put under the car capacity for plum of cooling liquid. Establish the handle of the switch of temperature in salon in the situation "CHAUD" (heating). Turn out a drain stopper of a radiator (fig. 2.70) on the right under the bottom tank and substitute capacity under merging liquid. Merge liquid from a broad tank.

Fig. 2.71. An arrangement of jams for air removal from cooling system: And — a stopper on the inlet pipeline; B — a stopper on a head of the block of cylinders


Turn out jams for air removal from system of cooling which are on the inlet pipeline and on the left side of a head of the block of cylinders (fig. 2.71).
Turn out a drain stopper on the block of cylinders (fig. 2.70, A). After the termination plum of cooling liquid wash out a large amount of water cooling system. Fill in water for washing in a bulk mouth of a radiator, previously having established into place, and then having unscrewed drain jams. Wash out a broad tank. Establish into place a drain stopper of the block of cylinders, then a stopper радиатоpa. Put a hermetic layer on a stopper of the block of cylinders.
Fill in cooling liquid through a radiator mouth in the small portions while it will not start to follow through openings for air removal from cooling system. When liquid will follow from openings without air vials, wrap jams in openings for air removal.
Fill a radiator to a maximum level and establish into place a stopper of a bulk mouth. Fill a broad tank to a label "MOVE". Start up the engine and warm up it to working temperature. Stop the engine and let's to it cool down. Check level of cooling liquid in a radiator and a broad tank; in case of need add liquid to a maximum level. Again start up the engine and repeat the above described operation until levels of cooling liquid in a radiator and a broad tank are not stabilized.

«previous page
4.9.2. Removal and installation of the water pump
following page»
4.10. Greasing system