Removal, installation and adjustment of a tension of a belt of a drive of the water pump. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and engine assembly
4.3. Block of cylinders
4.4. Shatunno-porshnevaya group
4.5. Cranked shaft and flywheel
4.6. Gazoraspredeleniye mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.9.1. Removal, installation and adjustment of a tension of a belt of a drive of the water pump
4.9.2. Removal and installation of the water pump
4.9.3. Washing and filling of system of cooling
4.10. Greasing system
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex control system of the engine (KSUD)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4 3000$ email

4-9-1-snyatie-ustanovka-i-regulirovka-natyazheniya-remnya-privoda-vodyanogo-nasosa.html

4.9.1. Removal, installation and adjustment of a tension of a belt of a drive of the water pump


Fig. 2.69. Adjustment of a tension of a belt of the water pump and placement of belts of a drive on engine pulleys: And — the GA14DE engine;
B — the GA16DE engine (without the conditioner); In — the GA16DE engine (with the conditioner): 1 — the top fastening of the pump of the hydraulic booster of a steering; 2 — the adjusting screw; 3 — a pulley of a cranked shaft; 4 — a pulley of the pump of the hydraulic booster of a steering; 5 — a pulley of the water pump; 6 — a generator pulley; 7 — a pulley of the compressor of the conditioner; 8 — a tension roller


Establish on supports a forward part of the car. Remove the right wheel and a mudguard. Remove the bottom guard of protection of the engine. Weaken the top fastening of the pump of the hydraulic booster of a steering and the adjusting screw reduce a tension of a belt of a drive of the water pump. Remove a belt. Clear pulleys. Examine a belt condition. Lay a belt in streams of pulleys (fig. 2.69) and adjust the screw 2 a belt tension, that by pressing effort of 10 kgfs to a belt branch between pulleys of the water pump and the power steering pump its deflection
made for a new belt of 3 — 5 mm, for working 4 — 6 mm.
Tighten fastening of the pump of the hydraulic booster of a steering. Execute necessary assembly operations as it should be, the return to removal.

«previous page
4.9. Cooling system
following page»
4.9.2. Removal and installation of the water pump