Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. Wheels and tires
4.2. Suspension bracket
4.2.1. Forward suspension bracket
4.2.2. Removal, check and installation of the forward shock-absorber and spring
4.2.3. Removal, check and installation of the forward stabilizer
4.2.4. Removal, check and installation of the forward top lever
4.2.5. Back suspension bracket
4.2.6. Removal, check and installation of the back shock-absorber
4.2.7. Removal and installation of a back cylindrical spring
4.2.8. Removal and installation of the back top lever
4.2.8.1. Removal
4.2.8.2. Installation
4.3. Tables
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








4-2-8-snyatie-i-ustanovka-zadnego-verkhnego-rychaga.html

4.2.8. Removal and installation of the back top lever





ATTENTION
Performance of the following procedures without preliminary removal of the sensor of speed of a wheel of anti-blocking system of brakes can lead to chain break in a plait of wires if the plait is by mistake tense.
Before performance of the following operations remove the sensor of speed of a wheel of anti-blocking system of brakes (from a nave) and fix it in a suitable place where the sensor will not be by mistake damaged at service performance.

Back top lever
Fig. 4.32. Back top lever: 1–sensor of speed of a wheel of anti-blocking system of brakes; 2–cable of lay brake system; 3–bolt (the lower part of the back shock-absorber); 4–bolt (a forward part of longitudinal draft); 5–bolt (the back top lever); 6–back top lever; 7–plug of the back top lever



«previous page
4.2.7.2. Installation
following page»
4.2.8.1. Removal