Check and installation of an initial corner of an advancing of ignition. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and engine assembly
4.3. Block of cylinders
4.4. Shatunno-porshnevaya group
4.5. Cranked shaft and flywheel
4.6. Gazoraspredeleniye mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.10. Greasing system
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex control system of the engine (KSUD)
4.13.1. Subsystem of management of fuel injection
4.13.2. Subsystem of management of a corner of an advancing of ignition
4.13.3. Preliminary checks
4.13.4. Check of electric parameters of a control system by the engine
4.13.5. KSUD self-diagnostics
4.13.6. Check and idling and contents adjustment WITH in the fulfilled gases
4.13.7. Check and installation of an initial corner of an advancing of ignition
4.13.8. Check of a technical condition of the sensor of a detonation (on the SR20DE engine)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

4-13-7-proverka-i-ustanovka-nachalnogo-ugla-operezheniya-zazhiganiya.html

4.13.7. Check and installation of an initial corner of an advancing of ignition


Fig. 2.96. Labels for installation of an initial corner of an advancing of ignition (UOZ)


Warm up the engine to working temperature. Connect a stroboscope according to the instruction. Rasstykuyte I will corrode the sensor of provision of a butterfly valve. Start up the engine and leave it to idle. Check a corner of an advancing of ignition, directing a lamp beam on the labels put on a pulley of a cranked shaft (fig. 2.96). If necessary weaken fastening of the distributor of ignition and, turning the distributor, establish a corner of an advancing of ignition according to recommended value. Tighten fastening of the distributor of ignition. Again check a corner of an advancing of ignition and disconnect a stroboscope. Join the socket of the sensor of provision of a butterfly valve.

«previous page
4.13.6. Check and idling and contents adjustment WITH in the fulfilled gases
following page»
4.13.8. Check of a technical condition of the sensor of a detonation (on the SR20DE engine)