Removal and installation of an oil radiator of the SR20DE engine. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and engine assembly
4.3. Block of cylinders
4.4. Shatunno-porshnevaya group
4.5. Cranked shaft and flywheel
4.6. Gazoraspredeleniye mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.10. Greasing system
4.10.1. Removal, check and installation of the oil pump
4.10.2. Check of pressure of oil
4.10.3. Removal and installation of an oil radiator of the SR20DE engine
4.10.4. Removal and installation of the oil pallet of the SR20DE engine
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex control system of the engine (KSUD)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 







993f9bf4 993f9bf4 993f9bf4

4-10-3-snyatie-i-ustanovka-maslyanogo-radiatora-dvigatelya-sr20de.html

4.10.3. Removal and installation of an oil radiator of the SR20DE engine


Fig. 2.76. Details of an oil radiator of the SR20DE engine: 1 — the oil filter; 2 — the case of the oil filter; 3, 5 — a sealing ring; 4 — an oil radiator; 6 — the central bolt


The oil radiator is established on the case of the oil filter and (fig. 2.76) fastens a bolt in a back part of the block of cylinders.
Lift a forward part of the car and put it on supports.
Merge liquid from cooling system. Disconnect hoses from the case of an oil radiator. Mark the provision of a radiator before it to remove. Turn out the central bolt. Will substitute capacity for collecting following oil. Remove sealing rings. Clear a radiator and blow it the compressed air. If the radiator is damaged or corked, replace it new.
At assembly replace sealing rings. Establish a radiator on the labels made earlier. Tighten the central bolt. Execute the remained operations as it should be, the return to removal. Start up the engine and be convinced of lack of a leak. If necessary add oil and cooling liquid.

«previous page
4.10.2. Check of pressure of oil
following page»
4.10.4. Removal and installation of the oil pallet of the SR20DE engine