Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.2.1. General information
3.2.2. Check and oil replacement in a mechanical transmission
3.2.3. Removal and installation of the sensor of a speedometer of the car (without anti-blocking system of brakes)
3.2.4. Epiploon replacement (differential)
3.2.5. Removal and installation of the mechanism of gear shifting
3.2.6. Coupling case, dismantling of elements of a case of the main transfer
3.2.7. Check and assembly of components of differential and case of the main transfer
3.2.7.1. Installation of bearings of a gear gear wheel
3.2.7.2. Assembly of a cylindrical pin
3.2.7.3. Adjustment of a preliminary tightness in the bearing
3.2.7.4. Differential installation in a coupling case
3.2.7.5. Installation of a case of the main transfer
3.2.7.6. Elimination of gaps of primary, secondary shaft and shaft of differential of a case of the main transfer
3.2.7.7. Measurement of loading of primary, secondary shaft and shaft of differential of a case of the main transfer
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








3-2-7-proverka-i-sborka-komponentov-differenciala-i-kartera-glavnojj-peredachi.html

3.2.7. Check and assembly of components of differential and case of the main transfer






Assembly components of differential
Fig. 3.50. Assembly components of differential: 1–gear wreath and case; 2–the bearing (from a gear wreath); 3–leading gear wheel of a drive of a speedometer; 4–bearing (from outside, opposite to a gear wreath); 5–persistent washer; 6–semi-axial gear wheel; 7–persistent washer; 8–satellite; 9–axis of satellites; 10-cylindrical pin



NOTE
Assembly carry out in an order specified in drawing 3.50. Installation of separate components of differential and as procedures of check are given below, in this section.

«previous page
3.2.6.1. Check of elements of primary shaft
following page»
3.2.7.1. Installation of bearings of a gear gear wheel