Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Greasing system
2.7.1. Check of pressure of oil
2.7.2. Replacement of engine oil
2.7.3. Installation of the oil filter
2.7.4. Removal and installation of the oil pallet
2.7.5. Removal and installation of the oil pump
2.7.6. Dismantling, check and assembly of the oil pump
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-7-2-zamena-motornogo-masla.html

2.7.2. Replacement of engine oil

Establish a vehicle on a horizontal surface.
Warm up the engine to normal working temperature.
Stop the engine and wait for 5 minutes.
Take out щуп for measurement of level of oil.

Check of level of oil on masloizmeritelny щупу
Fig. 2.288. Check of level of oil on masloizmeritelny щупу


Check that oil level – between labels of F and L on щупе and estimate a condition of engine oil. If oil level – is lower than a label of L, add oil (fig. 2.288).

ATTENTION
If in the course of oil replacement its some quantity casually gets on working parts of the engine, wipe it as it is possible more carefully. The remains not threadbare oil can cause smoke in a motor compartment.

Uncover a maslonalivny mouth and a drain stopper of the oil pallet and the oil filter.
Merge engine oil in the container.
Establish a drain stopper of the oil filter with a new sealing ring.
Inhaling moment (drain stopper of the oil filter): 9–10 N · m.
Clear a flange of a drain stopper of the oil pallet) and establish a stopper into place.
Inhaling moment (drain stopper of the oil pallet): 25–30 N · m.
Again fill in in the engine engine oil of the specified type and in the specified quantity.

«previous page
2.7.1. Check of pressure of oil
following page»
2.7.3. Installation of the oil filter