Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Greasing system
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine
2.13.2. Removal and installation of the sensor of provision of a cranked shaft
2.13.3. Removal and installation of the sensor of provision of a butterfly valve
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-13-3-snyatie-i-ustanovka-datchika-polozheniya-drosselnojj-zaslonki.html

2.13.3. Removal and installation of the sensor of provision of a butterfly valve

Uncover the storage battery.
Disconnect a negative wire from the storage battery.
Execute the following procedure for ensuring convenience of access.
Remove the air filter.
Remove an air hose.

Removal of the sensor of provision of a butterfly valve
Fig. 2.343. Removal of the sensor of provision of a butterfly valve


Remove the sensor of provision of a butterfly valve (fig. 2.343).
Be convinced of that the butterfly valve is completely closed.
Establish the sensor of provision of a butterfly valve on a throttle branch pipe.
Inhaling moment: 1,6–2,4 N · m.
Be convinced of that the butterfly valve moves smoothly.
Connect the socket of the sensor of provision of a butterfly valve.
Be convinced of that tension of a target signal of the sensor of provision of a butterfly valve (PID WDS: the provision of a butterfly valve) – within norm when the zaslonka is open or closed.
If does not correspond to norm, check the sensor of provision of a butterfly valve.

«previous page
2.13.2. Removal and installation of the sensor of provision of a cranked shaft
following page»
2.14. Tables