Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Greasing system
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine
2.13.2. Removal and installation of the sensor of provision of a cranked shaft
2.13.3. Removal and installation of the sensor of provision of a butterfly valve
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-13-2-snyatie-i-ustanovka-datchika-polozheniya-kolenchatogo-vala.html

2.13.2. Removal and installation of the sensor of provision of a cranked shaft

ATTENTION
At replacement of the sensor of position of the crankshaft, make sure that on it there are no extraneous subjects, type of metal sawdust.
In the presence of sawdust or shaving the target signal of the sensor will be distorted owing to fluctuations of a magnetic stream that will lead to deterioration of work of a control system of the engine.

Uncover the storage battery.
Disconnect a negative wire from the storage battery.
Execute the following procedure for ensuring convenience of access.
Remove the bottom cover.

Removal of the sensor of position of the crankshaft
Fig. 2.342. Removal of the sensor of position of the crankshaft


Remove the sensor of position of the crankshaft (fig. 2.342).
Establish as it should be, the return to removal.
Moment of an inhaling of the sensor of position of the crankshaft: 7,8–10,8 N · m.

«previous page
2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine
following page»
2.13.3. Removal and installation of the sensor of provision of a butterfly valve