Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions). Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Main data
11.2. Body repair
11.3. Heating and ventilation system
11.4. Climatic installation (conditioner)
11.5. System of safety cushions and prednatyazhitel of seat belts
11.5.1. Switching off and turning on of the block of a safety cushion and pyrotechnic device of seat belts
11.5.2. Removal and installation of the block of a safety cushion from the driver
11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)
11.5.4. Removal and installation of the block of a safety cushion of the passenger
11.5.5. Seat belts with a pyrotechnic prednatyazhitel
11.5.6. Removal and installation of the pyrotechnic device of a pretension of seat belts
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

11-5-3-snyatie-i-ustanovka-povorotnogo-vyklyuchatelya-so-spiralnojj-pruzhinojj.html

11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)


Fig. 9.53. Rotary switch: 1 — a label on a rotor; 2 — a label on a motionless part;
3 — fastening screws



Remove the safety cushion block from the driver. Disconnect wires of a sound signal and remove a steering wheel, thus forward wheels should be in the provision of rectilinear movement. Remove a casing of a shaft of a steering. Turn out four bolts of fastening of the switch (fig. 9.53), disconnect its shtekerny block and take the rotary switch.
Before installation be convinced that forward wheels are in situation for rectilinear movement. Establish the rotary switch, having combined a label 1 (see fig. 9.53) on a rotor with a label 2 on a motionless part. Connect a shtekerny block and screw screws of fastening of the switch.
Establish a casing of a shaft of a steering. Establish a steering wheel and the safety cushion block, having attached wires to a shtekerny block of the block of a pillow and to a sound signal.

«previous page
11.5.2. Removal and installation of the block of a safety cushion from the driver
following page»
11.5.4. Removal and installation of the block of a safety cushion of the passenger