Removal and installation of the block of a safety cushion from the driver. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Main data
11.2. Body repair
11.3. Heating and ventilation system
11.4. Climatic installation (conditioner)
11.5. System of safety cushions and prednatyazhitel of seat belts
11.5.1. Switching off and turning on of the block of a safety cushion and pyrotechnic device of seat belts
11.5.2. Removal and installation of the block of a safety cushion from the driver
11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)
11.5.4. Removal and installation of the block of a safety cushion of the passenger
11.5.5. Seat belts with a pyrotechnic prednatyazhitel
11.5.6. Removal and installation of the pyrotechnic device of a pretension of seat belts
12. Appendices
13. Electric equipment schemes
 







993f9bf4

11-5-2-snyatie-i-ustanovka-bloka-podushki-bezopasnosti-so-storony-voditelya.html

11.5.2. Removal and installation of the block of a safety cushion from the driver
Fig. 9.50. Block of a safety cushion of the driver: 1 — the fastening screw with RESISTORX T50 marking; 2 — the block socket; 3 — the control unit


Disconnect the safety cushion block. Turn out fastening bolts with marking of RESISTORX T50 of the block of a pillow (see fig. 9.50). Slightly raise the block and disconnect its socket. Remove the block of a pillow and put it on storage, observing thus safety regulations.
Installation of the block make in sequence, return to removal. Replace new bolts of fastening of the block. Perform operation of turning on of the block of a pillow.

«previous page
11.5.1. Switching off and turning on of the block of a safety cushion and pyrotechnic device of seat belts		 following page»
11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)