Filling of climatic installation. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Main data
11.2. Body repair
11.3. Heating and ventilation system
11.4. Climatic installation (conditioner)
11.4.1. Filling of climatic installation
11.4.2. Removal and compressor installation
11.4.3. Removal and installation of a belt of a drive of the compressor
11.4.4. Removal and installation of a protective casing of the evaporator
11.5. System of safety cushions and prednatyazhitel of seat belts
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

11-4-1-zapravka-klimaticheskojj-ustanovki.html

11.4.1. Filling of climatic installation

System filling by a coolant is made only by means of special equipment at filling station. In need of performance of a number of works in podkapotny space or at repair of a body moving of units of climatic installation is allowed provided that pipelines will not be disconnected. When undocking a contour of circulation of a coolant it is necessary to replace a dehumidifier and oil in the compressor.

Fig. 9.47. Arrangement of unions of climatic installation: And — the petrol engine;
B — the diesel engine; 1 — the union of a high pressure; 2 — the union of low pressure



The arrangement of unions of installation is shown on fig. 9.47.

    PREVENTIONS
At work with system of circulation of a coolant it is necessary to observe the following precautionary measures.
1. Avoid coolant hit on skin, in eyes, in respiratory ways. If it occurred, it is necessary to wash out the struck sites a large amount of water, and then to address in medical institution.
2. Any works with a coolant should be carried out in well aired room. Consider that the coolant is heavier some air therefore at leak can accumulate in osmotrovy ditches and other low places.
3. Cars with the conditioner are forbidden to be placed in the drying chamber with temperature over 80 ° With for the term of more than 20 minutes.
4. At a sink of a motor compartment do not direct a stream of hot water on knots of climatic installation.
5. For filling of climatic installation it is necessary to use only materials recommended by manufacturer.
6. Do not smoke about the car if central air was depressurized. In case of system depressurization surely replace a dehumidifier.
7. It is strictly forbidden to repair knots of climatic installation with welding or soldering application.
8. In need of process of repair work of moving of knots of climatic installation in podkapotny space it should be made, without separating system pipelines.


«previous page
11.4. Climatic installation (conditioner)
following page»
11.4.2. Removal and compressor installation