Removal and cowl installation. Nissan Almera (from 1995 to 1999 of release)
Nissan Almera service from 1995 to 2000 in N15 body
1. General information
2. The general requirements to car repairs
3. Operation and car maintenance
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Main data
11.2. Body repair
11.2.1. Removal and cowl installation
11.2.2. Removal and installation of a front bumper
11.2.3. Removal and installation of a rear bumper
11.2.4. Removal and installation of a forward wing
11.2.5. Removal and installation of lobbies and back doors
11.2.6. Removal and installation of an upholstery of forward doors
11.2.7. Removal and installation of an upholstery of back doors
11.2.8. Removal and installation of window regulators of lobbies and back doors
11.2.9. Removal and installation of the external handle of a door
11.2.10. Removal and installation of locks of doors
11.2.11. Removal and installation of glasses
11.2.12. Removal and installation of a door of a back (type body hatchback)
11.2.13. Removal and trunk lid installation (type body sedan)
11.2.14. Removal and dashboard installation
11.3. Heating and ventilation system
11.4. Climatic installation (conditioner)
11.5. System of safety cushions and prednatyazhitel of seat belts
12. Appendices
13. Electric equipment schemes
 









993f9bf4 993f9bf4 993f9bf4

11-2-1-snyatie-i-ustanovka-kapota.html

11.2.1. Removal and cowl installation


Fig. 9.1. Cowl details: 1 — a cowl; 2 — a noise isolation; 3 — rubber consolidation; 4 — an emphasis; 5 — an adjustable emphasis of a cowl; 6 — the cowl lock; 7 — draft of a drive of the lock of a cowl


Open a cowl and by means of the assistant, supporting it from both parties, turn out bolts of fastening of a cowl to loops (fig. 9.1). Remove a cowl.

Fig. 9.2. Adjustment of provision of a cowl:
1 — screws of fastening and cowl adjustment


Fig. 9.3. Adjustment of a clamp of the lock of a cowl: 1 — screws of fastening of a clamp of the lock of a cowl


Fig. 9.4. Gaps between apertures and opening parts of a body: and = (3,5±1) mm; in, g, д — (5±1) mm


Also together establish a cowl and turn, without tightening, bolts of fastening of a cowl to loops. Achieve such provision of a cowl that the lock was closed at height of installation of a cowl on 1 — 1,5 mm lower than level of forward wings (fig. 9.2). Achieve a uniform gap between interfaced details of a body. Tighten cowl bolts. Weaken bolts of fastening of the lock of a cowl (fig. 9.3), then 2 — 3 times open and close a cowl that the lock occupied the correct situation then tighten bolts of fastening of the lock. By means of an adjustable rubber emphasis establish the provision of a cowl in the closed condition on 2 mm below level of forward wings. Be convinced of uniformity of a gap between a cowl, wings and the forward panel of a body. On fig. 9.4 sizes of gaps which should be at installation of doors, a cowl and a car luggage carrier are specified.

«previous page
11.2. Body repair
following page»
11.2.2. Removal and installation of a front bumper